Mhouse GDX01, Инструкция по установке и эксплуатации, Страница: 10 / 214

04 . Use two screws to secure the ends of the chain into the groove on
the carriage plate (
fig. 14 ).
05 . Fit the spring on the support supplied ( fig. 15-a ) and insert the
assembly in the carriage plate (the plate not used to secure the
chain) (
fig. 15-b ).
06 . Join the two carriage plates; insert the screw in the support of the
drive pulley; position the drive pulley in the chain and mount the
assembly onto the drive bracket with the pin supplied (
fig. 16 ).
07 . Insert the chain and carriage inside the guide, taking care to observe
the following:
Fig. 17-a) position the side of the carriage with the chain fixed with
the screws on the same side as the contro unit cover;
Fig. 17-b) position the carriage to approx. mid-way on the guide.
08 . Pass the chain around the pinion of the gearmotor and close the
assembly with the protection cover (
fig. 18 ).
09 . Insert the bracket on the end of the guide and secure the two ele-
ments by means of a nut and washer (
fig. 19 ).
STEP 5
5.1 – INSTALLING THE AUTOMATION COMPONENTS
WARNINGS
• Incorrect installation may cause serious physical injury to those
working on or using the system.
• Before starting automation assembly, make the preliminary checks
as described in STEP 3.
After laying the electric cables, proceed with assembly of the mechanical
parts of the guides and gearmotor, in the sequence specified below.
01. Only for models GDX and GDXP : using a mallet, securely join the
three guide sections inside the two joining brackets ( fig. 11 ).
Important – the guides must slide inside the brackets until they click
firmly into place.
02 . Insert the guide in the seat on the gearmotor ( fig. 12 ).
03 . Insert the travel limit mechanical stop ( a ) in the guide and move it
close to the gearmotor; then position plate ( b ) onto the stop and
secure the assembly by means of a screw ( fig. 13 ). Note – The
screw must NOT be tightened excessively as the limit stop must
later be moved to its final position.
INSTALLATION: COMPONENT ASSEMBLY AND CONNECTIONS
11
12
13
V6 x 30
R06 (open)
b
a
14
15-a
15-b
V3,5 x 15
16
V8 x 45
English
10 – English