MG ChargeHub 11, Инструкция по эксплуатации

Страница: 42 / 51

INSTRUCTION MANUAL
MG MOTOR
42
Important note: Once STA mode is enabled, you can no longer access the Web
Configuration via the WiFi named “MG_ChargeHub” until you change it back to AP
mode by Ethernet cable. However, you can still access the Web Configuration via
Ethernet.
Once you’ve set your networking priorities correctly, make sure the AP band of the WiFi is 2.4G band. In
Australia and NZ, a typical router can broadcast a 2.4G WiFi and a 5G WiFi by default. 2.4G is preferred
as it can broadcast over longer distances.
While setting up your Router, WPA2 is the recommended encryption method.
B.3.2.1 Connecting to local WiFi
a) Click on “Software Setting”.
b) Check “WiFi enable”.
c) Set “Mode selection” to STA.
d) Fill in the correct SSID (WiFi Name), Psw (Password) and the same encryption method (normally
WPA2) as your WiFi connection.
e) Click “Dhcpc enable” (Essential, otherwise it will not have Internet access)
f) Click “Submit”.
Then refresh the web page to check the connection via “Charging status” - “Status Check”.
Note that once STA mode is enabled, you can no longer access the Web Configuration via the WiFi
named “MG_ChargeHub” until you change it back to AP mode by Ethernet cable.