C
ompressed-air Stapling Plier
Z 23 P
Page:
15
Mod.:
01/2022
ET
Seite 15 von 34 31.01.22 P:\Technik\ZANGEN\Z 23 P\Bedienungsanleitung\Englisch\Manual Z 23 P Pneum en_01_2022.docx
12.2
Check condition
WARNING
Risk of injury when operating a damaged stapling device or if accessories are
not attached correctly.
Check the condition of the stapling device before each use.
Make sure the stapling device is not damaged.
Check the following points in particular:
•
All parts of the stapling device and all accessories must be attached securely.
•
The safety equipment must not be blocked or otherwise hindered in function.
•
The spring on the trigger safety must not be damaged.
•
No part of the stapling device or accessories may show external damage such as scratches
or dents.
•
The hose must be undamaged.
Scratches on the paint of the housing or the magazine are not damage.
Do not connect a damaged stapling device to an air supply.
If the stapling device is damaged, have it repaired by technical personnel before resuming
use.
12.3
Connect stapling device to air supply
You can connect the stapling device to a compressor or a compressed air system.
Operation with a compressor or a compressed air system is permissible only under the following
conditions
The operating pressure of the compressor or the compressed air system must not be more
than 10% greater than the maximum operating pressure of the stapling device. Information
on the operating pressure of stapling devices can be found on page 23 in this section.
For compressed air systems with higher pressure, a pressure regulating valve (pressure
reducer) with a pressure relief valve connected downstream must be installed in the
compressed air line.
The compressed air must be filtered, dry, and oiled with special oil.
A compressed air preparation unit must be installed on the coupling side at the outlets for the
compressed air line to the stapling device. It must include
•
a filter
•
a water separator
•
an oiler
