64
My-Netti.com
Model:
Netti Dynamic AdaptPro
Language:
English
Version:
2021-11
Always use both pelvic and shoulder
restraints to reduce the possibility of head
and chest impact with vehicle components.
Watch out that the belt is not twisted and
the release buckle will not get in contact
with the chair in case of a crash.
If the user is 1.85 m or longer, the back
extension kit must be mounted when Netti
Dynamic AdaptPro is used as a seat in a car.
If a Netti head support is mounted correctly
it is very stable but does not replace the
need for an external neck support mounted
in the car.
Always use Netti Cushions when Netti
Dynamic AdaptPro wheelchair is used as a
seat in a car.
Never use the wheelchair as a seat in a car if
it has been involved in an accident with
impact, before the chair has been inspected
and approved for this by the manufacturer¨s
representative.
Netti Dynamic AdaptPro with seat width 500
mm and more, exceed the max width of 700
mm specified in PRM-TSI and have influence
on the possibility for train transport.
7.2 FOLDING FOR TRANSPORT
When the wheelchair is unoccupied, fold it as
described below. Put the wheelchair in the trunk or
the back seat. When placed in the back seat, secure
the frame using safety belts.
• Remove head support (chap. 6.9.5)
• Swing push-bow up (chap. 6.9.1)
• Revolve the arm supports up (chap. 6.9.4)
• Remove leg supports (chap. 6.9.6)
• Remove backrest cushion
• Release backrest and fold it forwards (chap. 5.5)
• Remove main wheel (chap. 5.3)
• Remove front castor (chap. 5.3.3)
7.3 TRANSPORT IN AIR-PLANE
Netti Dynamic AdaptPro wheelchair may be
transported in air-plane without any restrictions.
Netti Dynamic AdaptPro wheelchairs are equipped
with 3 gas cylinders. These are however not
classified as dangerous goods.
Netti Dynamic AdaptPro is configured with dynamic
function which are activated with gas spring(s).
Contrary to general dangerous goods instruction
UN3164, the IATA-DGR (special regulation A114)
rules that the goods that contain gas and are
determined to function as shock absorbers
(including energy-absorbing devices or pneumatic
springs) are NOT subject to the transport
instructions i.e. they are indemnified from the
following requirements:
a)
each article has a gas volume which does not
exceed 1,6 l and a charge pressure not exceeding
250 bar, where the product of the capacity
expressed in litres and charge pressure expressed
in bars does not exceed 80.
b)
Each article has a minimum burst pressure of 4
times the charge pressure at +20 degree Celsius
for products not exceeding 0,5 l gas space
capacity.
c)
Each article is made of material that will not
fragment.
d)
Each article was manufactured in accordance
to quality standard which is approved by the
responsible national authority.
e)
It is proven and shown that the article relives its
pressure by means of a fire degradable seal or
other pressure relief device such that the article
will not fragment and the article does not rocket.
7.4 TRAVELLING ON PUBLIC
TRANSPORT
The wheelchair should be put in a special area for
wheelchairs. The recline and leg support dynamic
functions must be locked.
The wheelchair should face opposite the direction of
travel. The back of the wheelchair must be located
against a fixed object such as a row of seats or a
partition. Make sure the user can easily reach any
hand rails or handles. Use belts and harnesses in the
chair to hold the user. Use safety belts if available to
secure the user in the vehicle.
