Metos SP-30HA-W, Инструкция по эксплуатации

Страница: 8 / 36

8
Metos Marine Mixer SP-30HA, SP-40HA 15.05.2015
Fitting the bowl
With the bowl cradle lowered, place the chosen mixing
tool in the bowl and position the bowl on the cradle.
There are three location points when fitting the bowl.
(1) The locking pin at the rear of the bowl should locate
in the hole of the cradle.
(2) The two holes in the bowl handles must engage
on the pins located on the cradle.
(3) Please ensure that the bowl is seated correctly on
the cradle before securing the bowl locking latches
prior to use.
Fitting the mixer tool
Slide the bayonet fitting of the agitator onto the drive shaft and twist
clockwise to secure it in position. To remove the agitator, slide the tool up
the shaft slightly and twist counter clockwise. Please refer to Figure 3.
NOTE: Install the bowl BEFORE inserting agitators.
NOTE: Agitators should always rotate in a clockwise direction around
bowl. If agitators move counterclockwise, please contact licensed elect-
rician immediately to remedy incorrect wiring.
Bowl lift & Bowl Guard
The bowl cradle and bowl guard are electrically interlocked so that the machine will
only operate with the bowl cradle at the raised position. In addition to this, the bowl
guard must be locked into place by sliding it into position across the top of the bowl
to the point where it will slide no further.
NOTE: Only once the bowl is raised and the bowl guard locked, the machine can ope-
rate. Thus ensuring total user safety at all times. Once the guard has been opened or
the bowl lowered, the machine will stop immediately. The Mixer can only be restarted
by pressing the start button again.
During the mixing process, additional ingredients can be added by the chute located
on the right hand side of the bowl guard.
The removable Bowl Guard
The interlocking bowl guard now is available to remove for cleaning purpose. With
separated handles, it can easy take out the bowl guard and cleaning in a sink or
dishwasher.
Fig A
Open / Closing the Bowl Guard
To open the bowl guard, holding the separated
handle, and rotating clockwise. (See Figure A)