Metos SP-30HA-W, Инструкция по эксплуатации

Страница: 5 / 36

15.05.2015
5
Metos Marine Mixer SP-30HA, SP-40HA
INSTALLATION INSTRUCTIONS
Installation
The machine is supplied factory lubricated and ready to run. It should be positioned
on any solid, level and non-skid work surface that is nonflammable. Install in work
area with adequate light and space.
• For safety, the mixer should be BOLTED in position using all four holes located
in the legs.
• DO NOT attempt to lift the mixer alone.
• Clean the mixer before use. It is normal for the factory
to apply a generous amount of grease in and on the
machine before initial use.
• During the transportation or fitting, please do not lean
over 35 degree to avoid the gear oil leaking from the
gear oil container.
• Please use forklift to transporting.
Electrical connection
CAUTION: NEVER USE EXTENSION CORD. Low amp supply could damage the
mixer or cause a fire.
Before connecting this machine to the electrical supply, check that the details on the
rating plate (located on the rear of the machine) correspond to the details of your
electrical connection.
The mixer is supplied with a trailing lead fitted with a molded plug. If the style of plug
is unsuitable for the socket you plan to use, the plug must be cut off and replaced
with an appropriate plug.
Machines are fitted with a color coded three core cable as follows: Brown: Live , Blue:
Neutral. Green/Yellow: Earth
As the color of the wires may not correspond to the colored markings identifying the
terminals in your plug, you should proceed as follows:
• The wire which is colored blue must be connected to the terminal which is marked
with the letter N or colored black.
• The wire which is colored brown must be connected to the terminal which is
marked with the letter L or colored red.
• The wire which is colored green/yellow must be connected to the terminal which
is marked with the letter E or colored green.
NOTE: In terms of the 3-phase , when the mixer is located and connected with the
plug, please make sure that the shaft goes clockwise . (Same direction as the arrow
sticker that located on the front of the machine) If the shaft goes counterclockwise,
please replace the wires: R.S.T. (USA) L1, L2, L3, (Europe). To replace the wires
each other until the shaft goes clockwise.