17
OPERATION MANUAL
5. OPERATION INSTRUCTIONS
5.1
PRE-OPERATIONAL SAFETY CHECK PRIOR TO OPERATING
Before operating the machine the rear safety beam guard needs to
be checked. Below are the steps that need to be followed.
1. Start machine as per instruction procedures
2. Stand outside rear safety gate & obstruct sensor (1)
3. Ensure machine has stopped and is disabled
4. Check your control: Warning light (A)
5. Press green reset button at the rear of electrical box image (C)
6. If red light on control panel is off continue to step 7
7. Repeat steps 1 to 6 for each sensor (2) & (3)
A: Basic Control - Light on
Emergency Stop Check,
B: Rear Guarding Sensors
C: Guard Reset Button
1. Start machine as per instruction procedures
2. Press the emergency stop buttons on the control panel and front of the machine. (E)
3. Ensure the machine has stopped and is disabled
4. Reset emergency stop button by twisting the red dial. (D)
(Some models need guard to also be reset)
5. Repeat steps 1 to 4 for each emergency stop on your machine
E: Emergency Stop
D: Guard Reset Button
(1)
(2)
(3)
Page 17
Instructions Manual for MG-440 (S924A)
07/02/2018
