Messoa NIC910/930/950HPro, Инструкция по эксплуатации, Страница: 55 / 68

55
INSTALLATION INSTRUCTIONS
9.1.5 Parapet Wall Mount
Daughter Wall Installation Instructions
(1) Remove the secure plate and drill 8 holes on the wall matching the mount
holes on the plate. Diameter φ3/8” (9.5mm), depth 1/1/2” (40mm) (Figure 1).
(2) Hammer 8 screw mounts into the holes and then secure the plate with a hex
driver (Figure 2).
(3) Fasten the connector ring to the L tube in the clockwise direction (Figure 3).
(4) Thread the cabling of the main unit through the short aluminum tube and
push the cables out from the bottom (Figure 4).
(5) Pull out the cables and connect the main unit to the connector ring in the
clockwise direction (Figure 4).
(6) Use hex driver to secure the stop screw to the connector ring and fasten the
safety cable to the tube (Figure 5).
(7) Insert the entire tube (including the main unit) into the hole fitting on the
secure plate (Figure 6).
(8) Rotate the tube clockwise until 180° with the secure plate, and then fasten
the screws (Figure 7).
(9) Installation completed (Figure 8).
Note:
When using water sealant, the entire portion of the spiral tooth of the
connector ring must be applied with the sealant. This will prevent rain water
leaking through the connection.
The holes on the wall support are of diameter φ 10 mm. Please use screws
of φ 8~9mm, and make sure the drilled holes are of correct size to ensure
proper installation.
When drilling the hole, please make sure the wall thickness is greater than
50mm in order to maintain its structural integrity.
Warning:
When using in an outdoor environment, the safety cable must be connected
to the main unit and safety wire screw hole. This will avoid personal hazards
if the unit falls from its installation.
Make sure there are no damaged parts during assembly.
A Expansion anchor
B Fixed plate
C Hexagon head nuts
D Hole
E Gland
Figure 1