Messoa NIC910/930/950HPro, Инструкция по эксплуатации, Страница: 45 / 68

PRESET COMMANDS
The following commands are for use with DVR Tyco Protocol
45
Command
Name
Description DVR Tyco
Pan Left Pan left (24°/sec) until Pan V
Pan Right
Pan right (24°/sec) until Pan
Stop
V
Pan Stop Stop Panning V
Tilt Up Tilt up until Tilt Stop V
Tilt Down Tilt down until Tilt Stop V
Tilt Stop Stop Panning V
Focus Near Focus Near until Focus Far or Focus Stop V
Focus Far Focus Far until Focus Near or Focus Stop V
Focus Stop Stop focus V
Zoom In Zoom in(telephoto) until Zoom Out or Zoom Stop V
Zoom Out Zoom in(wide angle) until Zoom Out or Zoom Stop V
Zoom Stop Stop zoom V
Iris Open Opens iris (manual iris mode)/lightens Iris Preference™ offset
(auto iris mode) until Iris Close or Iris Stop
V
Iris Close Close iris (manual iris mode)/darkens Iris Preference™ offset
(auto iris mode) until Iris Close or Iris Stop
V
Iris Stop Stop iris offset adjustment (also stops V-Phase Adjust) V
Define Pattern 1 Start defining Pattern 1 V
Define Pattern 2 Start defining Pattern 2 V
Define Pattern 3 Start defining Pattern 3 V
Mark Target 1 Store the current position as Target 1 V
Mark Target 2 Store the current position as Target 2 V
Mark Target 3 Store the current position as Target 3 V
Mark Target 4 Store the current position as Target 4 V
Mark Target 5 Store the current position as Target 5 V
Mark Target 6 Store the current position as Target 6 V
Mark Target 7 Store the current position as Target 7 V
Go to Target 1 Go to preset position called Target 1 V
Go to Target 2 Go to preset position called Target 2 V
Go to Target 3 Go to preset position called Target 3 V
Go to Target 4 Go to preset position called Target 4 V
Go to Target 5 Go to preset position called Target 5 V
Go to Target 6 Go to preset position called Target 6 V
Go to Target 7 Go to preset position called Target 7 V
Run Pattern 1 Run Pattern 1 V
Run Pattern 2 Run Pattern 2 V
Run Pattern 3 Run Pattern 3 V
Pattern End Tells the dome to stop recording (defining) a pattern V
Flip Pan 180
o
from the current position. V
Enter Dome Menu Display dome menu and enters menu mode V
Exit Dome Menu Exits dome menu and returns to normal dome operation
Proportional speed Proportional speed pan or tilt movement commands
Set Preset Store the current position as the specified preset.
Go to Preset Positions to preset specified by preset number.