MerCruiser 305 CID (5.0L), Руководство по обслуживанию

Страница: 131 / 895

MCM MODELS SERVICE MANUAL NUMBER 24
90-861327--1 OCTOBER 1999 Page 2A-15
Alignment
CAUTION
DO NOT use an alignment tool from another manufacturer. Alignment tools other
than Quicksilver Alignment Tool 91-805475A1, may cause improper alignment and
damage to gimbal bearing and/or engine coupler.
CAUTION
To avoid damage to gimbal bearing, engine coupler, or alignment tool:
•
DO NOT attempt to force alignment tool!
•
DO NOT raise or lower engine with alignment tool inserted (or partially
inserted) in gimbal bearing or engine coupler.
1. Align engine as follows:
a. Attempt to insert solid end of Quicksilver Alignment Tool through gimbal bearing and
into engine coupler splines. If it will not insert easily proceed to following.
b. If the tool does not fit, remove it and carefully raise or lower the from end of the
engine, as necessary, and attempt to insert the alignment tool.
c. Repeat step “b” until the alignment tool installs easily (SLIDES FREELY) all the way
into and out of engine coupler splines.
70013
b
a
a - Alignment Tool (Use Only Quicksilver Alignment Tool (91-805475A1)
b - Insert This End of Alignment Tool through Gimbal Housing Assembly
72585
b
c
a
a - Alignment Tool
b - Gimbal Bearing
c - Engine Coupler
IMPORTANT: Turn both front engine mount adjustment nuts an equal amount in
direction required to align engine.
Index