P 10
Please retain product label and instructions for future reference
40mm
screw
Pre drill
hole
*
Cut to fit
Step 15
Parts needed - No. 37 QTY 23
Place the first roof board (
No. 37
)
onto the log cabin, making sure the boards
are flush to the end of the roof purlin.
Ensure there is an even amount of
overhang between the log boards and roof
board at the front and back of the cabin.
Once in position fix to the purlin, front and
back of the log cabin using 3x40mm
screws.
Use the spacer (
No. 43
) to create an
expansion gap between each roof board if
installing during low levels of moisture
(Summer.) This creates an expansion gap
for the boards to move into during high
levels of moisture (Winter.)
Once in position fix the roof boards to the
purlin, front and back of the log cabin
using 3x40mm srews per roof board.
*Please Note
: The Purlin will be longer
than the log boards by 2mm each end.
You have been issued with 23 roof boards,
but in reality you may only need to use 22.
The last roof board will overhang
past the end of the roof purlin. Using a
straight edge and a pencil, mark out a line
as a guide.
Cut along the pencil mark and remove the
excess. Place the cut down board’s back
onto the roof and secure into place using
3x40mm screws per board.
*Please Note:
This image is for illustrative
purposes and may differ from your choice in
product. Nevertheless the process of cutting
and fitting the last roof board(s) is the same.
69x40mm Screws
a
a
b
37
b
37
Step 16
Parts Needed - No. 39 QTY 2
Ensuring the roof boards are flush and level,
fix the eaves frames (
No. 39
) to the under-
side of the roof boards using 9x30mm
screws as shown in the illustration
*Please Note:
This image is for illustrative
purposes and may differ from your choice in
product. Nevertheless the process of fixing the
eaves frames is the same.
18x30mm Screws
30mm
screw
Pre drill
hole
39
