P 13
Please retain product label and instructions for future reference
40mm
screw
Pre drill
hole
*
Cut to fit
38
38
Step 22
Parts Needed - No. 38 QTY 21
Place the first floor board (
No. 38
)
inside the building flush to the log
board on one side. Continue adding
the floor boards (
internally
) making
sure to interlock each individual board.
You have been issued with 21 floor
boards, but in reality you may only
need to use 20.
*Do
NOT
secure the boards until the
last board has been measured and
cut.
Following the same method outlined
previously measure the gap between
the bottom of the tongue (
on the last
board placed
) and the log board.
Using a straight edge mark out the
measurement onto the last floor board
(
No. 38
) and cut along the length
removing the excess.
**Please note:
Mark the final board
2mm under the measurement; This will
allow the timber to expand and contract
correctly.
Once all the floor boards are in position
secure each board into position using
6x40mm screws per board.
***Please Note:
Ensure to screw
through each of the floor boards into the
floor bearers.
126x40mm Screws
Closure Trim
Internal
23
*Measure and cut the
closure trims to
fit the internal space.
Closure Trim
Internal
40
*Measure and cut the
closure trims to
fit the internal space.
Pre drill
hole
30mm
screw
*
trim to fit
Step 2.
Parts needed - No. 40 QTY 4
Inside the building place the closure
trim (
No. 40
) against the boarding and
align with the roof as shown in the
illustration.
*Measure and cut the closure trims to
fit the internal space.
Once in position fix each trim into
place by pre drilling a pilot hole and
using 6x30mm screws per trim,
equally spacing them along the face
of the board.
24x30mm Screws
Roof
Roof
23
23
40
40
30mm
screw
Pre drill
hole
*
Cut to fit
Step 24
Parts needed - No. 40 QTY 4
Once the floor has been laid arrange the
closure trim (
No. 40)
around the outside
edge of floor (
internally
), measure and cut
down accordingly to best match the
internal space.
Secure each trim section into place using
6x30mm spaced equally along the board
as shown in the illustration.
*Do NOT fix the closure trim to the floor
boards.
24x30mm Screws
