Mercedes-Benz EQS 350, Руководство оператора

Страница: 236 / 581

#
Point remote control
5
from a distance of
1 cm to 8 cm towards button
1
,
2
or
3
.
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green continu-
ously. Programming is complete.
R
Indicator lamp 4 flashes green. Program-
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
#
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
#
Release all of the buttons.
%
The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
Synchronising the rolling code
Requirements:
R
The door system uses a rolling code.
R
The vehicle must be within range of the garage
door or door drive.
R
The vehicle as well as persons and objects are
located outside the range of movement of the
door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1 , 2
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
%
Please also read the operating instructions for
the door drive.
Troubleshooting when programming the remote
control
#
Check if the transmitter frequency of remote
control
5
is supported.
#
Replace the batteries in remote control 5 .
#
Hold remote control 5 at various angles from
a distance of 1 cm to 8 cm front of the inside
rearview mirror. You should test every position
for at least 25 seconds before trying another
position.
#
Hold remote control
5
at the same angles at
various distances in front of the inside rear
view mirror. You should test every position for
at least 25 seconds before trying another
position.
#
On remote controls that transmit only for a
limited period, press button 6 on remote
control 5 again before transmission ends.
#
Angle the aerial line of the garage door opener
unit towards the remote control.
%
It is possible that older garage doors cannot
be operated using the remote control in the
inside rearview mirror even after you have
successfully performed the measures descri-
bed above. If this is the case, contact the
HomeLink
® Hotline.
%
Support and additional information on pro-
gramming:
R
on the HomeLink
®
Hotline on (0) 08000
466 354 65 or +49 (0) 6838 907-277
R
on the Internet at https://
www.homelink.com
Driving and parking 233