*
NOTE Invalidation of the operating per‐
mit due to failure to comply with the
instructions for installation and use
The operating permit may be invalidated if
the instructions for installation and use of RF
transmitters are not observed.
#
Only use approved frequency bands.
#
Observe the maximum permissible out‐
put power in these frequency bands.
#
Only use approved aerial positions.
1
Front roof area
2
Rear roof area
3
Rear wing
4
Boot lid
On vehicles with a panoramic sliding sunroof, fit‐
ting an aerial to the front or rear roof area is not
permitted.
On the rear wings, it is recommended that you
position the aerial on the side of the vehicle
closest to the centre of the road.
Use Technical Specification ISO/TS 21609 (Road
Vehicles – EMC guidelines for installation of
aftermarket radio frequency transmitting equip‐
ment) when retrofitting RF (radio frequency)
transmitters. Comply with the legal requirements
for detachable parts.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial con‐
nections intended for use with the basic wiring.
Be sure to observe the manufacturer's Supple‐
ments when installing.
Two-way radio transmission output
The maximum transmission output (PEAK) at the
base of the aerial must not exceed the values in
the following table:
340 Technical data
Содержание E 300
