Interior
18
Overall vehicle
Introduction to CITAN, Model Series 415
l
Partition walls and load protection grilles
Various partition wall and load protection grille options are available for the Citan to safely isolate the passenger
compartment from sliding loads in the cargo area.
Panel van
• Full-width partition wall without window (standard)
• Full-width partition wall with window (SA)
• Omission of partition wall (SA)
• Steel load protection grille, folding, for passenger
side or full-width (SA).
If the passenger seat is folded down, the cargo area
can be extended by the space over the folded seat.
The hinged section can be folded through 90° behind
the passenger seat to protect the driver from the
cargo.
Mixto
If the partition wall is omitted, an inside rearview attached to the windshield mirror can be included. The
manually adjustable, antiglare rearview mirror is installed as standard on the passenger van and is otherwise
available as an option. It can be omitted on panel vans with partition wall but is still installed if a light/rain sensor
is ordered because this is located in the mirror housing.
• Fixed steel load protection grille on C-pillar (SA).
The fixed steel load protection grille is attached to
the C-pillar behind the rear bench seat. It allows up
to five people plus cargo to be transported simulta-
neously.
• Folding 1st row 3-passenger bench seat with load
protection grille (SA). This 3-passenger bench seat
incorporates a folding load protection grille at the
rear. Folding down the rear bench seat allows the
cargo area to be enlarged if necessary and the
bench seat acts as a load protection grille. The
bench seat can then no longer be used. This turns
the five-seater Mixto into a two-seater with highly
variable cargo area.
S68.74-4503-00
Partition wall with window (SA)
S68.74-4504-00
Load protection grille (SA)
– This printout will not be recorded by the update service. Status: 09 / 2012 –
