X
Start the engine of the donor vehicle and run it at idling speed.
X
Connect negative terminal
?
of donor battery
B
to ground point
A
of your vehicle using the
jumper cable, connecting the jumper cable to battery of other vehicle
B
first.
X
Start the engine.
X
Before disconnecting the jumper cables, let the engine run for several minutes.
X
First, remove the jumper cables from ground point
A
and negative terminal
?
, then from pos-
itive clamp
;
and positive terminal
=
. Begin each time at the contacts on your own vehicle first.
X
Close cover
:
of positive terminal
;
after removing the jumper cables.
X
Have the battery checked at a qualified specialist workshop.
PLUG-IN HYBRID vehicles: if your vehicle has been jump-started, it may not be possible to use the
electric drive for approximately 30 minutes.
Jump-starting is not considered to be a normal operating condition.
i
Jumper cables and further information regarding jump-starting can be obtained at any qualified
specialist workshop.
Towing and tow-starting
Important safety notes
G
WARNING
Functions relevant to safety are restricted or
no longer available if:
R
the engine is not running.
R
the brake system or the power steering is
malfunctioning.
R
there is a malfunction in the voltage supply
or the vehicle's electrical system.
If your vehicle is being towed, much more
force may be necessary to steer or brake.
There is a risk of an accident.
In such cases, use a tow bar. Before towing,
make sure that the steering moves freely.
G
WARNING
When towing or tow-starting another vehicle
and its weight is greater than the permissible
gross weight of your vehicle, the:
R
the towing eye could detach itself
R
the vehicle/trailer combination could roll-
over.
There is a risk of an accident.
When towing or tow-starting another vehicle,
its weight should not be greater than the per-
missible gross weight of your vehicle.
Details on the permissible gross vehicle weight
of your vehicle can be found on the vehicle iden-
tification plate (
Y
page 432).
!
When COLLISION PREVENTION ASSIST
PLUS, DISTRONIC PLUS or the HOLD function
is activated, the vehicle brakes automatically
in certain situations.
To avoid damage to the vehicle, deactivate
these systems in the following or similar sit-
uations:
R
when towing the vehicle
R
in the car wash
!
Make sure that the electric parking brake is
released. If the electric parking brake is faulty,
visit a qualified specialist workshop.
!
Only secure the tow rope or tow bar at the
towing eyes, or the trailer tow hitch, if availa-
ble. You could otherwise damage the vehicle.
!
Do not use the trailer tow hitch for recovery
or towing. Do not use the towing eye for
recovery. this could damage the vehicle. If in
doubt, have the vehicle recovered using a
crane.
!
When towing, pull away slowly and
smoothly. Pull the towed vehicle as straight as
possible and not at an acute angle. Excessive
tractive power could damage the vehicles.
When towing, it is preferable to use a rigid tow-
ing bar as opposed to a tow rope. A rigid towing
bar helps to keep the tractive power low.
!
When towing vehicles with KEYLESS-GO,
use the key instead of the Start/Stop button.
Towing and tow-starting
381
Bre
akdow
n
assi
tanc
e
Z
Содержание 2016 GLE
Страница 96: ...set correctly If this is not the case repeat the steps above 94 Side windows Opening and closing...
Страница 449: ...447...
Страница 450: ...448...
