Programming
Programming buttons
Pay attention to the "Important safety notes"
(
Y
page 352).
Garage door remote control
A
is not included
with the integrated garage door opener.
X
Turn the SmartKey to position 2 in the ignition
lock (
Y
page 145).
X
Select one of buttons
;
to
?
to use to con-
trol the garage door drive.
X
To start programming mode: press and
hold one of buttons
;
to
?
on the integrated
garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp
:
lights up yellow.
Indicator lamp
:
lights up yellow as soon as
button
;
,
=
or
?
is programmed for the
first time. If the selected button has already
been programmed, indicator lamp
:
will only
light up yellow after ten seconds have
elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards but-
tons
;
to
?
on the rear-view mirror at a dis-
tance of 2 to 8 in (5 to 20 cm).
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green: pro-
gramming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is to
synchronize the rolling code (
Y
page 353).
X
Release button
B
on remote control
A
for
the garage door drive system.
If indicator lamp
:
lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door opener
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least
25 seconds before trying another position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(
Y
page 352).
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you will
need to use the programming button on the door
drive control panel. The programming button
may be positioned in different places depending
on the manufacturer. It is usually located on the
door drive unit on the garage ceiling.
Familiarize yourself with the garage door drive
operating instructions, e.g. under "Program-
ming of additional remote controls", before car-
rying out the following steps.
Your vehicle must be within reach of the garage
door or gate opener drive. Make sure that nei-
ther your vehicle nor any persons/objects are
present within the sweep of the door or gate.
X
Turn the SmartKey to position 2 in the ignition
lock (
Y
page 145).
X
Get out of the vehicle.
X
Press the programming button on the door
drive unit.
Usually, you now have 30 seconds to initiate
the next step.
X
Get into the vehicle.
X
Press previously programmed button
;
,
=
or
?
on the integrated garage door opener
multiple times until the door closes.
The rolling code synchronization is then com-
plete.
Notes on programming the remote con-
trol
Canadian radio frequency laws require a "break"
(or interruption) of the transmission signals
after broadcasting for a few seconds. Therefore,
these signals may not last long enough for the
integrated garage door opener. The signal is not
recognized during programming. Comparable
Features
353
Stowage
and
features
Z
Содержание 2016 GLE
Страница 96: ...set correctly If this is not the case repeat the steps above 94 Side windows Opening and closing...
Страница 449: ...447...
Страница 450: ...448...
