Mercedes-Benz 2016 GLE, Руководство оператора

Страница: 372 / 450

X
Open the tailgate.
X
Lift the cargo compartment floor upwards
(
Y
page 337).
X
Remove the "Minispare" emergency spare
wheel (
Y
page 427).
Flat tire
Preparing the vehicle
Your vehicle may be equipped with:
R
MOExtended tires (tires with run-flat proper-
ties)
Vehicle preparation is not necessary on vehi-
cles with MOExtended tires
R
a TIREFIT kit (
Y
page 369)
R
an emergency spare wheel (only for certain
countries)
Information on changing and mounting wheels
(
Y
page 408).
X
Stop the vehicle on solid, non-slippery and
level ground, as far away as possible from
traffic.
X
Switch on the hazard warning lamps.
X
Secure the vehicle against rolling away
(
Y
page 178).
X
If possible, bring the front wheels into the
straight-ahead position.
X
Vehicles with the AIRMATIC package:
make sure that the normal vehicle level is
selected (
Y
page 207).
X
Vehicles with the Off-Road Engineering
package: make sure that the normal vehicle
level is selected (
Y
page 201).
X
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove the
SmartKey from the ignition lock.
X
Vehicles with KEYLESS-GO: open the driv-
er's door.
The on-board electronics now have status 0.
This is the same as the SmartKey having been
removed.
X
Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock
(
Y
page 146).
X
Make sure that the engine cannot be started
via your smartphone (
Y
page 148).
X
Make sure that the passengers are not endan-
gered as they do so. Make sure that no one is
near the danger area while a wheel is being
changed. Anyone who is not directly assisting
in the wheel change should, for example,
stand behind the barrier.
X
Get out of the vehicle. Pay attention to traffic
conditions when doing so.
X
Close the driver's door.
X
Unload heavy luggage.
i
Only operate the tire inflation compressor
using a 12 V socket, even if the ignition is
turned off (
Y
page 343).
An emergency cut-out ensures that the on-
board voltage does not drop too low. If the on-
board voltage is too low, the power to the
sockets is automatically cut. This ensures
that there is sufficient power to start the
engine.
MOExtended tires (tires with run-flat
properties)
General notes
With MOExtended tires (tires with run flat char-
acteristics), you can continue to drive your vehi-
cle even if there is a total loss of pressure in one
or more tires. The affected tire must not show
any clearly visible damage.
You can recognize MOExtended tires by the
MOExtended marking which appears on the
sidewall of the tire. You will find this marking
next to the tire size designation, the load-bear-
ing capacity and the speed index (
Y
page 403).
MOExtended tires may only be used in conjunc-
tion with an active tire pressure loss warning
system or with an active tire pressure monitor.
If a pressure loss warning message appears
in the multifunction display:
R
observe the instructions in the display mes-
sages (
Y
page 309).
R
check the tire for damage.
R
if driving on, observe the following notes.
The driving distance possible in run-flat mode is
approximately 50 miles (80 km) when the vehi-
cle is partially laden and approximately 18 miles
(30 km) when the vehicle is fully laden.
In addition to the vehicle load, the driving dis-
tance possible depends upon:
R
vehicle speed
R
road condition
R
outside temperature
370
Flat tire
Breakdow
n
assitanc
e