Mendota ML39- AA-11-04391, Инструкция по установке и эксплуатации

Страница: 56 / 95

85-03-01205 ML-SERIES FIREPLACE Page 56
CA UTIO N: A lways use one 7 /1 6 ” ope n e nd wr e nc h and one lar ge plie r s or vic e gr ips tool to hold, loose n and
tighte n pilot hood base to pr e ve nt damage to pilot mount br ac ke t.
4.8.1.2 Converting the Pilot
6. While holding the pilot base body with large vice grips tightly, loosen the pilot’s hex - shaped base using a 7/16” open end
wrench. Rotate counter clock-wise ¼ turn to loosen.
7. Pilot arrives from the factory set for natural gas. Push natural gas/LP adjustment clip inward all the way to set it for LP. See
detail view, below. If you see “NAT” printing on the adjustment clip, this indicates that the pilot is set to burn natural gas. Push
the c lip in so that “NAT” is not visible.
8. Tighten down hex-shaped base of pilot using a 7/16 ” open end wrench.
9. After the pilot is converted reinstall the burner and floorplate. Remember to be careful when placing the floor plate around the
pilot to avoid damaging the pilot.
4.8.1.3 Pressure Regulator Conversion
10. Next, the pressure regulator will be changed. Access the pressure regulator thr ough the right-side access panel. If the fireplace
is already installed, the valve can be accessed from inside the firebox.
Figure 4-5 Pilot Body
Figure 4-6 Pilot Orifice Selection
Figure 4-7 Pinch Pilot Base with Vice
Grips