Mendota FV44i-PF2, Инструкция по установке и эксплуатации

Страница: 46 / 52

45
How to move the Backup DC Power Inlet Port
To move the Backup Battery Power Inlet Port to a new location, follow
these instructions.
1. Locate the DC Power Inlet Port connector which is mounted di-
rectly beneath the Master Switch.
2. Remove the L
eft Control Panel by removing 4 screws (1/4’
Hex). This will give you direct access to the rear of the Backup
DC Inlet Port fitting.
3. Loosen and remove the securing nut for the Inlet Port fitting
then lift it up and out carefully while guiding the wires through
the open slot.
4. Carefully pull the Inlet Port fitting and its connecting cable out of
the body of this appliance through a hole provided at the front
of the Left Control Panel.
5. Determine where you wish to mount the DC Inlet Port (front
face or left side return flange).
6. Push the partially cutout knockouts through careful-
ly using a small screw driver.