Mendota FV44i-PF2, Инструкция по установке и эксплуатации

Страница: 35 / 52

34
Burner Orifices
#65-14-00054[54 DRILL]
#65-14-00055[55 DRILL]
Motorized
LP Pressure
Regulator
[10.0-5.5"WC]
# 907.012
55
54
NATURAL TO LP GAS CONVERSION
Kit # HA-58-00302 for Mendota Model FV-44i
This conversion kit shall be installed by a qualified service agency in
accordance with the manufacturer’s instructions and all applicable
codes and requirements of the authority having jurisdiction. If the in-
formation in these instructions is not followed exactly, a fire, explosion
or production of carbon monoxide may result causing property dam-
age, personal injury or loss of life. The qualified service agency is re-
sponsible for the proper installation of this kit. The installation is not
proper and complete until the operation of the converted appliance is
checked as specified in the owner instructions supplied with the kit.
Caution : The electrical supply to the fireplace must be turned off prior
to performing the conversion. The gas supply must be shut off prior to
disconnecting the electrical power.
ORIFICE SIZES REQUIREMENT
:
A Natural Gas to LPG conversion kit #HA-58-00302 must be ordered
and installed to convert the FV-44i Fireplace to burn LPG.
LP Conversion Kit # HA-58-00302 contains the following parts: One Motorized LP Pressure Regulator #907.012 and two
Cap Orifices (
drill #54 and drill #55) .
Recommended Procedure to Convert This Fireplace To Burn LPG
This Fireplace Insert arrives from the factory ready to burn Natural Gas. If you intend to burn LPG, it is highly recommended that you
convert this fireplace and its Pressure Regulator, Pilot Orifice Thimble and Burner Orifices prior to placing this fireplace in its fire-
place cavity.
See diagrams, on this page, and follow these instructions to prepare this fireplace for conversion to LPG.
1. Using a ¼” Hex Driver, remove 4 screws that secure the Log Grate in place. Remove Grate from Firebox.
2. Remove the Floor Brick Panels by lifting them out of the firebox.
3. Remove the left-side access panel mounted to the left outer skin and lay down gently without disconnecting any wires of internal
components.
REMOVE SCREWS
FIRST.
REMOVE LOG GRATE
FLOOR PANELS
LIFT UP AND
REMOVE
FLOOR PANELS