Mendota FV44i-PF2, Инструкция по установке и эксплуатации

Страница: 30 / 52

29
TEMPERATURE INDICATOR (
o
F or
o
C)
1.
Press the ON/OFF Key and Turn Off the Fireplace.
2. Simultaneously, Press both the MODE Key and the Thermostat
Key.
3. Look at the LCD display to verify that your desired indicator (
o
F or
o
C) is being displayed. If not, repeat step 2.
KEY LOCK FUNCTION
To prevent unsupervised children from operating the fireplace, a KEY LOCK function is
provided with this remote control system. To activate the KEY LOCK function, simultane-
ously press the “MODE KEY” and the “UP KEY”. To deactivate the KEY LOCK function,
simultaneously press t
he “MODE KEY” and the “UP KEY”.
During KEY LOCK mode, none of the Keys will function. You must DEACTIVATE the sys-
tem before you can use the Remote Transmitter.
LOW BATTERY POWER DETECTION
1. Transmitter Batteries : The life span of the remote control transmitter batteries depends
on various factors: quality of the batteries used the number of ignitions of the appliance,
the number of changes to the room thermostat set point, etc. When the Transmitter bat-
teries are low, a Battery Icon will appear on the LCD display of the Transmitter before all
battery power is lost. When the batteries are replaced, this icon will disappear.
2. Wall Receiver Batteries : The life span of the wall receiver batteries depend on the qual-
ity of the batteries used and how long the batteries have been installed in the wall receiver. These batteries are only
utilized during power outages. Replace these batteries every heating season even if you have not experienced any
power outages. Batteries drain slowly even when not in use. This is a normal characteristic of all batteries.
OPERATING DURING POWER OUTAGES
This electronic ignition system utilizes the supplied 110VAC power when it is available for all functions of this system. If
the AC power is interrupted during a power outage, plug in the battery pack (6V DC Max, supplied with this fireplace) to
the Fireplace Backup Power Inlet Port installed on the wall to the left side of the fireplace (located about 18” up from floor
level).
During the power outage, the appliance’s burners will
function. In addition, Flame Height adjustment and
Secondary Burner ON/OFF functions will be availa-
ble. The Fan and Accent Light, which are wholly de-
pendent on 110VAC power, will not function.
This appliance is designed and tested to be operated
during power outages. The overall efficiency of this
appliance will be reduced by approximately 5% when
the blower function is disabled during the power out-
age period.
You may operate this appliance indefinitely on bat-
tery power as long as you accept that high capacity
DC 6 volt batteries will be required to sustain uninter-
rupted DC power to this appliance and that the blow-
er function and accent light functions will not be
available.