Mendota FV44i-PF2, Инструкция по установке и эксплуатации

Страница: 11 / 52

10
14. Remove the Vent Adapter
by removing two 5/16”
Hex Bolts and sliding Vent Adapter towards rear of
Insert.
15. Tightly secure
3” and 4” flex vents with clamps
provided. Seal vent cap/flashing to top of chimney
with weatherproof sealer. Seal areas between flex
pipes and existing chimney, at damper area, with
unfaced fiberglass insulation.
16. Carefully slide Insert into the fireplace opening
(Note: Plug in the AC Power cord to a 110 volt AC
receptacle inside the fireplace opening or extend it
out and connect to a grounded wall outlet.
17. Slide Vent Adapter forward between guide rails.
Vent Adapter’s front flat section should contact in-
sert top as you slide the Vent Adapter forward.
18. Use Glass Latch Tool to grab Vent Adapter
through slot and hole provided. As you apply
downward pressure, pull Vent Adapter forward un-
til front flange on Vent Adapter is about ½” away
from front lip on Insert.
19.
Slide 5/16” Hex Bolts through holes in face of
Insert and start one Bolt in each of the two press
nuts on Vent Adapter Flange. Usi
ng a 5/16” Hex
Hand Driver, tighten the hex bolts a few turns at a
time alternating between the two hex bolts until the screws are hand tight and vent adapter is pulled fully forward.