Mendota AA-11-04109, Инструкция по установке и эксплуатации

Страница: 19 / 96

85-03-01154 FV36 DÉCOR Page 19
Fireplace Dimensions and Clearances
Caution: The distance from floor level to the centerline of the vent cap is based on Simpson DuraVent GS components.
If using vent components of another brand, do not assume that the measurement given here is applicable. Verify the
distance to the centerline of vent cap by measuring the components you are using.
Note: For every 1” this fireplace is raised off the floor, the non -combustible hearth protection pad may be reduced by
2”. If this fireplace is raised more than 6” off the floor, no hearth protecti on pad is required.
Note: Consult the R-Value Table for reference
72 MINIMUM
UNIT BASE TO CEILING
18 MINIMUM TO SOFFIT.
24" TO VINYL SOFFITS.
48 1/2
UNIT BASE TO
8" DEEP MANTEL
1 1/2 MAXIMUM
HEARTH PAD THICKNESS
18
HEARTH PAD
46 3/8
UNIT BASE TO
VENT CENTERLINE
8
54 MINIMUM
ENCLOSURE CEILING
HEIGHT
10 3/8
UNIT FACE TO
VENT CENTERLINE
20 MINIMUM
FRAMING DEPTH
50 MINIMUM
ENCLOSURE FRAMING WIDTH
43
FINISHED FRAMING WIDTH
16 MINIMUM
TO SIDE WALL
16
PROTRUSIONS IN THE HATCHED
AREA ARE ALLOWED.
41 MINIMUM
FRAMING HEIGHT
50 MINIMUM
ENCLOSURE FRAMING WIDTH
43
FINISHED FRAMING WIDTH
2 X 4 STUDS
AFTER THE UNIT IS IN PLACE
INSTALL TWO 2 X 4 STUDS TO
FINISH THE FRAMING AT THE
FRONT OF THE UNIT.
HATCHED AREA MUST BE COVERED WITH
NON-COMBUSTIBLE MATERIALS ONLY.
MINIMUM REQUIRED DIMENSIONS
ENCLOSURE FRAMING WIDTH 50"
FINISHED FRAMING WIDTH 43"
FRAMING HEIGHT 41"
FRAMING DEPTH 20"
FINISHING MATERIAL THICKNESS 1"
UNIT BASE TO ROOM CEILING 72"
TO SIDE WALL 16"
TO 8" MANTEL 48 1/2"