Memjet AS-1180C, Руководство по обслуживанию

Страница: 27 / 181

SECTION 2
TROUBLESHOOTING
25
Toolbox System Status Messages (continued)
Displayed, in red , in the M Series Toolbox utility.
SYSTEM STATUS PROBLEM SOLUTION
TILT_ERROR
or
EXCESSIVE_TILT_ERROR
The printer’s electronics
have detected that the
print engine is too far
out of level.
Tilt sensor needs to be
re-calibrated. If just powered on, wait a few minutes;
error may clear by itself. Once Tilt
level drops to 1.99 or less you can clear
the error using the “Clear Error” feature
in the Toolbox.
Make sure printer is placed on sturdy
surface and the body is level.
Do NOT move the printer while the
power is on.
If the Tilt level is 1.99 or less you can
clear this error using the Clear Error
feature in the M Series Toolbox.
Verify that printer is level and possibly
Zero the Tilt Sensor.
MECH_FAIL_PERMANENT
Reason: Sled lift failed
Reason: Ink valve failed
Reason: Sled home failed Mechanical failure or
sensor failure. One of
the printer’s mechanical
components was not
properly registered at the
expected position. If the Service Station was just installed;
check to be sure it was installed
properly.
Depending on the “reason”; check/ the
associated component and related
sensors.
Using the Scan Sensors page in the
Toolbox, perform the toggle test on the
Sensor responsible for registration of
the failed mechanical component
position.
Lifter Arm Sensor is dirty or damaged,
Lifter Motor Cable is unplugged,
operator's side Lifting Arm is damaged,
or the Lifting Arm mechanism is stuck.
Dual Pinch Valve problem: Check
Sensor board connector and
flag/sensors alignment. Check Valve
motor connector.
Check P2005 cable on MPCA.
At this point, this error may represent
an Ink Pump error, since there is no
return signal from the pump and
therefore, a separate message
describing an Ink Pump error.
Check/replace the Ink Pump.
[Crit 63 03-phead offline
cancelpage restart] Dirty Printhead contacts.
Printhead or Pen Board
fault.
Cable unplugged. Eject Printhead and inspect/clean
contacts.
Replace Printhead
Check cable connections between Pen
Board and Main PCB. Make sure
P250/260 & J250/260 cables were not
mistakenly swapped.