Memjet AS-1180C, Руководство по обслуживанию

Страница: 139 / 181

SECTION 4
DISASSEMBLY AND ASSEMBLY
137
18. Remove the Service Station from the print engine.
19. Re-install print engine and other components in reverse order.
Realign outline marks, from step 1, before securing the Clamshell to the deck (Ink Tank section).
Tip: Leave the side covers off until you are sure the printer is fully operations.
20. Power the printer on and verify proper service station motor drive and lift arm motor drive.
After power-up; the first thing you should notice is the lift arms raise, lower, then stop in the lowered
position. The printer does this to verify that the arms are in the lowest position before driving the
service station.
Then you should notice the Service Station drive components driving for a number of cycles. Then
they will stop. At this time the Toolbox will show a “Fatal Error 71 02…” message, indicating that the
printer is having problems recognizing and moving the service station components; this is normal,
since the Service Station is not installed.
21. Power-down the printer and disconnect the power cord from the printer.
22. Verify that the Lift Arms are in the lowered position and then re-install the service station. Be sure to
start it squarely and don’t drive it in more than 1/4” past when it engages with the drive gears.
CAUTION! Before you re-install the service station, you must be sure the Lifting Arms are lowered.
If not, the arms can be captured above the Service Station and the new arms may be broken when you
power-on the printer.
23. Power the printer on and test for proper operation.