Memak STELLA COMBINE, Инструкция по установке и эксплуатации

Страница: 50 / 68

50
I
memak.com
SAFETY
The instructions in this section apply only if the country code is shown on the device. If the
country code is not visible on the device, refer to the technical instructions that give the
necessary instructions for adapting the device to the current conditions in the country.
RULES
• Do not tamper with the machine and do not disable the safety systems of the machine.
• This appliance is for professional use. It should only be used by qualified personnel.
• Do not damage or disassemble the safety instructions on the top of the machine.
• If there is any damage, contact our company immediately and ask for a new one.
• In the event of danger, press the emergency stop button.
• Keep the machine and its working area clean and tidy.
• Persons with inappropriate psychological status should not use the machine.
• Wear appropriate personal protective equipment.
• Check the safety of your machine in accordance with the maintenance program.
• Do not perform any maintenance or repairs while the oven is connected to the power supply.
• Any maintenance or check operation must be carried out after disconnecting the machine from
the mains. When the inspection is finished, the protective covers and safety elements that have
already been removed must be installed and secured in place.
• Never wash the control panel and electronic control box with water.
• Do not use toxic and acidic solutions. If used, it may damage paint and synthetic materials.
• Avoid using petroleum based materials such as thinner.
• Make sure that the values of your electrical supply correspond to the electrical specifications of
the machine. The machine must be properly grounded before connecting it to the main power
supply.
• Burner must be connected to the furnace and commissioned by qualified personnel.
• Make sure that the values of your electrical supply are compatible with the electrical specifica-
tions of the machine. To avoid electrical risks, the machine must have a proper grounding line
before the machine is connected to the main power supply.
• Thermocouple connections must be connected to the thermocouple connection with the (+, -)
values indicated on the label of the digital control clock (Location: from the bottom on the 2nd
layer, next to the pool drain in the layer).
• Safety thermostat must never be deactivated for any reason. Thermostat should be used with
the same value and should exceed 320 ° C when it is changed due to any faults. (Connection
place; is connected to T and TI terminals in the front panel). (Location: in 3rd layer from bottom,
next to the pool drain in the layer).