Meinberg LANTIME, Руководство по эксплуатации

Страница: 83 / 153

NETBIOS cannot be used over IPv6 in this version. IPv4 and IPv6 can be used
together on one LANTIME.
To manage the interface specific parameters, you can enter the Ethernet Configuration
Line page by using one of the ETHERNET buttons. If your LANTIME is equipped
with only one network interface, you will find only one button (ETHERNET 0).
Otherwise you see one button for each installed Ethernet port.
Here, the parameters for the network port can be changed. In the upper section of the
page you can enter the IPv4 parameters, the lower part gives you access to the IPv6
parameters of the interface.
IPv4 addresses are built of 32 bits, which are grouped in four octets, each containing
8 bits. You can specify an IP address in this mask by entering four decimal numbers,
separated by a point “.”.
Example: 192.168.10.2
Additionally you can specify the IPv4 Netmask and your default gateway address.
Please contact your network administrator, who will provide you with the settings
suitable for your specific network.
If you are running a DHCP (Dynamic Host Configuration Protocol) server in your
network, the LANTIME system can obtain its IPv4 settings automatically from this
server. If you want to use this feature (you should also ask your network administrator
if this is applicable in your network), you can change the DHCP Client parameter to
“ENABLED”. In order to activate the DHCP client functionality, you can also enter
the IP address “000.000.000.000” in the LCD menu by using the front panel buttons
of the LANTIME. This is the default setting.
The MAC address of your timeserver can be read in the LCD menu by pressing the
NEXT button on the front panel twice. This value is often used by the network
administrator when setting up the DHCP parameters for your LANTIME at the
DHCP server.
83