Megger BITE 3, Инструкция по эксплуатации

Страница: 21 / 42

Controls, Connectors, Indicators & Menus
AVTMBITE 3 Rev 8 April 2014
15
The battery is too hot or too cold and charging has therefore been interrupted
until the battery returns to a temperature between 32°F and 115°F (0°C and
45°C). The stationary LEDs are flashing.
Input Voltage Too Low:
The charger supply is not supplying sufficient voltage to the battery module to
charge the batteries. The LED is progressing from right to left.
Battery nearly exhausted:
The battery capacity is very low. Recharge it. The one remaining LED is flashing.
Error: Reset:
An error has occurred within the battery module. The circuitry is resetting. Wait
a few moments and the fault should clear. The first, fifth, sixth and tenth LEDs
are flashing in unison.
Overvoltage problem:
The charging supply voltage is too high. Disconnect the charger and rectify the
fault. The LEDs will progress from outer LEDs to inner LEDs and vice versa.
F
WARNING
Connecting to greater than 15 volts can cause
permanent damage to the battery module.