9
EN
Installation and bringing the device into
operation
Disconnect the minus terminal on the car radio before the
installation.
There will be the danger of a short circuit and an electric shock!
The ISO slot
The car radio is intended for installation in a
standard ISO installation slot. It must be at
least 53 x 182 mm in size.
The ISO slot is usually equipped with two
ISO sockets and an aerial connector.
The cable sockets supplied with the device can be used if your vehicle does not
have an ISO installation slot or is not equipped with the connections. Contact
your specialist workshop, the specialist trade or the specialist departments of
department stores. Compare the Erläuterungen zu den Kabeln [Explanations about the
cables] chapter to this.
Installing the installation frame in the ISO slot
The installation frame (1) is pulled over the car radio (2) in the status at delivery. Pull
the installation frame off the casing first.
►
Push both the keys supplied with the device (3) to the left and the right between
the device and the installation frame until they engage to do this.
►
Then push the installation frame backwards across the device with the aid of the
keys.
►
Push the installation frame into the ISO installation slot (4).
►
Bend as many loops as possible outwards (5) with a screwdriver, to fix the
installation frame in the installation slot. Select those loops that are firmly
connected to the casing of the installation slot.
