Mecmesin 432-680, Руководство по установке и эксплуатации

Страница: 43 / 65

Mecmesin Interlocked Machine Guarding
Mecmesin

43
6.8 MultiTest- dV and OmniTest Interlock Function Test
The following section only applies to MultiTest-
dV
and OmniTest systems.
Work through the table below row-by-row setting the interlock key switch as per the first
column and the guard door position as per the second column.
For MultiTest- dV test stands, fit the interlock override plug when the first column states a
switch position of ‘0’ and the interlocked guard’s connector at switch position of ‘1’.
Next, invoke the test stand operation stated in the third column. This will involve either
manually jogging the test stand or attempting to run a test. Check the error message and
front panel status of the test stand against the ‘Error Message’ and ‘Front Panel’ columns:
Please refer to Section 7.2.1 for more information relating to VectorPro warning messages.
Should any of the above checks fail to indicate the correct test stand state or
operation, then consult your test stand's relevant user manuals. Seek assistance
from a local agent or Mecmesin Technical Support if the fault cannot be
rectified.
Failure to adhere to these checks could cause damage to both the end user and
test equipment. It may also affect the warranty terms.