Mean Well KSR-01IP, Инструкция по эксплуатации, Страница: 28 / 30

25
+
-
+
-
36
90
44.9
22.55
12.2
50.9
71
4
37.6
KS R- IP 01
KNX IP Router
I
Function
Bus State
IP TP
Traffic
GA PA
Prog
.
ME
U
AD
E I
N
Figure 24: Dimension drawings
7.FAQ
◎
The firmware update finished successfully but the device doesn´t work.
Turn the power off and on again (or dis-/reconnect bus line). Try to restart like this.
◎
Is it Ok to connect and disconnect the Ethernet cable quickly?
No! Don't do this. To observe, State IP LED will light green for a few seconds and
after that, the device will reset.
◎
What shows the Programming LED if the Ethernet cable is not connected?
When the cable is not properly connected, the Programming LED is blinking red.
◎
LED A2 Bus State KNX TP is continuously blinking green. Why?
This indicates KSR-01IP is in Boot Mode. For more information and how to switch
back to normal operation please refer to chapter 5.4 (Firmware) Update/Boot
Mode.
◎
I disabled DHCP and assigned a correct IP configuration, but I cannot
access the Web front-end. Why?
Reset the KSR-01IP and try again. More information about changing the IP
network configuration can be found in chapter 4.2 IP Configuration.
◎
I try to access the Web front-end but I'm not successful. What can I do?
Make sure the URL bar entry matches the correct IP address together with the
right HTTP port or use the MAC address in exactly the way as explained (see
chapter 5.1). Then wait for about 5 or 10 seconds, refresh the browser and try
again.