Mean Well KSR-01IP, Инструкция по эксплуатации, Страница: 19 / 30

16
5.WEB Front-End
The Web front-end can be used to readout KSR-01IP ´s actual device parameters
(HTTP port, IP address, MAC address, …), to update its firmware and to adjust the
(additional) tunnelling addresses. To identify a particular KSR-01IP of a KNX
network the Programming LED/Program Mode can be remotely switched on without
pressing the Program Button.
Note:To switch back from Boot Mode to normal operation it is necessary to run the
firmware update procedure.
5.1 Accessing the KSR-01IP Web Front-End
There are three ways to access the KSR-01IP. It can be accessed like a Microsoft
Windows UPnP network device (Windows7 or later) and by a web browser. For
access by a web browser either the IP address or the MAC address, together with
the HTTP port, have to be known. How to use IP address and MAC address with the
browser´s URL bar is described in the following.
Note: For access via web browser the HTTP port that is set by ETS (or the factory
default parameter value) has to be used.
Note: KSR-01IP is able to use both official HTTP system ports (80 and 8080).
Note: Factory default HTTP port is 8080.
5.1.1 via Windows Network UPnP
Figure 13: KSR-01IP as UPnP network device (“KNX TP IP”)
When the UPnP network function is enabled, KSR-01IP appears in the Windows
Network. A click on the KSR-01IP network device opens the Web front-end with the
standard web browser. If KSR-01IP is not visible as an UPnP network device a
manual restart is recommended. After that, the device becomes visible in the list of
network devices.