Use of open source software
General
Our products include, among other things, open source software, which is manufactured by a third party and
has been published for free use by anyone. The open-source software is available under special open-source
software licences and copyright of third parties. In principle, each customer can use open source software
free of charge under the licence terms of the respective manufacturers. The customer's right to use the open
source software for purposes other than those for which our products were intended is regulated in detail by
the relevant open source software licences. The customer may freely use the open source software as set out
in the respective valid licence, beyond the intended purpose of the open source software in our products. In
the event that there is a contradiction between the licensing terms of one of our products and the respective
open source software licence, the respective applicable open source software licence shall take priority over
our licensing terms if the respective open source software is affected by this.
Use of the open source software is free of charge. We do not charge any usage fees or similar charges for the
use of open source software included in our products. Customer use of open source software in our products
is not part of the profit that we obtain from the contractual remuneration. All open source software programs
contained in our products are in the available list. The most important open source software licenses are listed
in the Licences section at the end of this publication.
If programs that are included in our products are under the GNU General Public License (GPL), GNU Less-
er General Public License (LGPL), the Berkeley Software Distribution (BSD), the Massachusetts Institute of
Technology (MIT), or other open source software license, which requires that the source code be made avail-
able, and this software was not already supplied with our product on a disk or in the source code, we will send
this at any time upon request. If we are required to send this on a disk, there will be a flat rate charge of €35.00.
Our offer to send the source code upon request, shall automatically end 3 years after delivery of the respective
product to the customer.
Requests must, where possible, be sent to the following address with the product's serial number:
MB connect line GmbH Fernwartungssysteme · Winnettener Str. 6 · 91550 Dinkelsbühl GERMANY
Tel. +49 (0) 98 51/58 25 29 0 · Fax +49 (0) 98 51/58 25 29 99 · [email protected]
Special liability provisions
We assume no responsibility or liability if the open-source software programs included in our products are
used by customers in a manner that no longer corresponds to the purpose of the contract which serves as
the basis for the purchase of our products. This applies in particular to any use of the open source software
programs outside of our products. The warranty and liability provisions, which stipulate the applicable open
source software license for the corresponding open source software, as listed below, apply to the use of open-
source software beyond the contractual purpose. In particular, we are also not liable if the open source software
in our products or the entire software configuration in our products is changed. The warranty contained in
the contract, which forms the basis for the purchase of our products, applies only to unchanged open source
software and the unchanged software configuration in our products.
Open source software used
For a list of the open source software used in our products, visit https://www.mbconnectline.com/down-
loads/open-source-software-licenses.txt.
Page 14
von 324 | V 7.2.0 - en | Aug 25
th
, 2022 |
Содержание mbNET.rokey RKH 210
