Mazda 0000-8F-N02B, Руководство по установке

Страница: 6 / 26

6
4280159 Rev. A 10/10
1. Driver’s A-Pillar Trim Removal/Installation
a. Partially peel back the rubber weatherstrip away from the
A-pillar trim.
b. Pull the A-pillar trim, then disengage clips A. (FIGURE K)
c. Pull the A-pillar trim, then disengage clip B (Picture 1).
d. Pull the A-pillar trim upward, then disengage clip B from
the A-pillar trim (Picture 2).
e. Disengage the tabs from the dashboard, then remove the
A-pillar trim.
f. Pull clip B out, then rotate 45 degrees. (FIGURE L)
g. Remove clip B from the grommet by pulling it outward and
replace clip B into A-pillar trim for reassembly.
2. Clean mounting spot with an alcohol pad prior to mounting.
Mount the dipole antenna to the windshield 220 mm to the
right of the center of the mirror base on the windshield, di-
rectly below the black windshield frit. (FIGURE M)
CAUTION: Mounting dipole antenna on black windshield
frit will result in reduced operating range.
3. Run the antenna wire above the headliner to the driver’s A-
pillar, using a fiber stick to secure under the headliner.
(FIGURE M)
4. Route the antenna wire down the A-pillar, securing it to the
existing wire harness with (3) supplied, short wire ties.
(FIGURE N)
CAUTION: Do not secure antenna wire to the moonroof
drain tube, if equipped, or to any airbag components.
5. Route the antenna wire behind the left side of the dashboard
and over to the remote start control module. Plug the 2-pin
antenna connector into the 2-pin port on the bottom of the re-
mote start control module. (FIGURE O)
6. Re-install the driver’s side A-pillar panel and re-install the rub-
ber weatherstrip along the A-pillar.
A-PILLAR
UPPER TRIM
TAB
B
A
A
CLIP A
CLIP B
A-PILLAR
UPPER TRIM
GROMMET
(1)
(2)
DIPOLE ANTENNA MOUNTING
4
FIGURE M
FIGURE K
FIGURE L
FIGURE O
CLIP B
GROMMET
45
2-pin
FIGURE N
!
220 mm
Wire
Ties
220 mm
!