Mazda 0000-8F-N02B, Руководство по установке

Страница: 23 / 26

23
4280159 Rev. A 10/10
FINALIZING THE INSTALLATION
1. NOTE: After reassembling the vehicle parts, check for any dirt. Clean any dirty parts.
2. NOTE: After completing the installation, refer to the vehicle Owner’s Manual for instructions on how to reset the clock
and preset radio stations.
3. CAUTION: Disconnecting the battery may cause the DSC indicator light to become inoperable. (The DSC OFF
indicator light flashes and the TCS/DSC indicator light is illuminated.)
Perform the following procedure to restore the DSC to an operable condition, if applicable:
a. Start the vehicle with the key.
b. Turn the steering wheel completely to the right and then completely to the left.
c. Verify that the DSC OFF indicator light turns off.
d. Turn the ignition switch to the OFF position and then turn it to the ON position again.
e. Verify that the TCS/DSC indicator light turns off.
4. CAUTION: When the battery is disconnected, the windows will not fully open and close automatically.
Perform the following procedure to the driver and passenger front windows to resume operation:
a. Turn the ignition switch to the RUN position.
b. Press down the window switch on the front passenger’s side door panel and fully open the window.
c. Pull up the window switch on the front passenger’s side door panel and continue holding for approximately 3
seconds to fully close the window.
d. Press down both front window switches on the driver’s door panel and fully open the windows.
e. Pull up both front window switches on the driver’s door panel and continue holding for approximately 3 seconds to
fully close the windows.
f. Turn the ignition switch to the OFF position.
23
!
!
TROUBLESHOOTING GUIDE, continued
22
9. Vehicle’s Perimeter Alarm sounds during remote start operation.
a. Ensure remote start dome light fuse is placed in the (+) positive position (See Section 2).
b. Ensure the Yellow/Blue remote start wire is routed properly and is not cut or shorted on any vehicle components
(See Section 8).
c. Ensure good connection and correct vehicle wire at Key-in-sense connector (See Section 8).