Mazda 0000-8F-N02B, Руководство по установке

Страница: 13 / 26

13
4280159 Rev. A 10/10
Ribbon Cable
Non-conductor
side
Conductor
side
IMMOBILIZER INTERFACE RIBBON CABLE MOUNTING
9
1. Route the immobilizer interface ribbon cable to the ignition switch.
2. Following the instructions on the supplied adhesive primer stick,
apply a thin coating to the outer surface of the immobilizer antenna
coil (black plastic ring around ignition switch) and to the ribbon
cable.
CAUTION: Avoid primer contact to visible areas of the immobi-
lizer antenna coil and ignition switch to prevent possible discol-
oration of any plastic components.
3. Remove the backing from one side of the supplied 2-way tape and
apply tape around the immobilizer antenna coil (black plastic ring
around ignition switch) keeping the tape off of the rounded part of
the ignition switch face by trimming excess 2-way tape, if neces-
sary. (FIGURE EE & FF)
4. Remove the remaining backing on the 2-way tape and position the
2-conductor ribbon cable around the immobilizer antenna coil, with
the gray or black non-conductor side facing away from the ignition
key opening. (FIGURE GG, HH & JJ)
5. Separate approximately 100 mm of the twisted red or black ribbon
cable and create a second loop around the immobilizer antenna
coil directly in front (toward the ignition key opening) of the first
loop. (FIGURE GG, II & JJ)
6. Using (1) supplied, short wire tie, secure the antenna coil.
(FIGURE GG, II & JJ)
FIGURE EE
Smart-Key
CAUTION: THIS IS A CRITICAL STEP THAT MUST BE FOLLOWED
PRECISELY FOR PROPER REMOTE START OPERATION.
FIGURE FF
Retractable Key
FIGURE GG
Smart-Key
Retractable Key
FIGURE HH
First Loop
Second Loop
Wire Tie
FIGURE II
Retractable Key
Wire Tie
First Loop
Second Loop
FIGURE JJ
Retractable Key
First Loop
Second Loop
Wire Tie
!
!