Mazda 0000-8F-N02B, Руководство по установке

Страница: 20 / 26

20
4280159 Rev. A 10/10
IMMOBILIZER INTERFACE PROGRAMMING
NOTE: THE TACHOMETER SIGNAL MUST BE PROGRAMMED TO THE DNA CARD FOR THE REMOTE ENGINE
START FUNCTION TO OPERATE. (READ ENTIRE PROGRAMMING PROCEDURE PRIOR TO PROGRAMMING.)
1. Transponder interface programming:
NOTE: Two programmed ignition keys are required for this step and engine hood must be closed.
For Smart-Key equipped vehicles, remove keys from Smart-Key transmitters and place transmit
ters at least 10 feet away from vehicle during programming.
a. Sitting in the driver seat, be prepared to press the brake pedal to shut down the remote start
system.
b. Using the first key, turn the ignition on, wait for the THEFT light to turn off, then turn the ignition off and
remove key from the ignition switch.
c. Using the second key within 5 seconds, turn the ignition on, wait for the THEFT light to turn off, then
turn the ignition off and remove key from the ignition switch.
d. Activate the remote start function by pressing the START button (2) times within 5 seconds.
The system should flash the parking lights and chirp the horn one time, pause for four seconds
and start the engine
. If the engine fails to start and the THEFT light is flashing rapidly, see
Troubleshooting Guide (Section 22).
e. After the engine has started, press the brake pedal to shut down the engine. The Immobilizer
interface is now programmed.
f. Attach new Remote Engine Start transmitters to the keys.
19
TRANSMITTER PROGRAMMING
20
NOTE: THE FOLLOWING STEPS ARE ONLY NECESSARY IF YOU NEED TO PROGRAM ADDITIONAL
TRANSMITTERS.
1. Transmitter Programming
NOTE: The transmitters shipped with the remote engine start system are pre-programmed to
the DNA card and do not need to be reprogrammed.
a. Turn the ignition key to the RUN position.
b. Press and hold the programming button.
After 10 seconds the horn will beep 3 times, indicating that the system is now in transmitter learn
mode.
c. Release the programming button.
d. Press the START button once on each transmitter to be programmed.
The horn will beep 1 time to indicate that the transmitter has been learned.
NOTE: Up to a total of 8 transmitters can be programmed to the DNA card.