Mazda 0000-8F-N02B, Руководство по установке

Страница: 12 / 26

12
4280159 Rev. A 10/10
BR/B
C I
G
A
E
B D F H J L
K
WIRE HARNESS CONNECTIONS - STEERING COLUMN, continued
KEY-IN-SENSE CONNECTION
1. Locate the 12-pin (Smart-Key equipped) or 2-pin (Retractable
Key equipped) WHITE key-in-sense connector under the igni-
tion switch. (FIGURE AA)
2. Using a razor knife carefully cut back 1”-2” of the electrical tape
to expose the wiring. ( CAUTION: BE EXTREMELY CARE-
FUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE
AA & BB for proper connector and pin location.
!
FIGURE CC
FIGURE DD
VIEW FROM HARNESS SIDE
FIGURE AA
FIGURE BB
VIEW FROM HARNESS SIDE
VEHICLE’S PUSH WIRE REMOTE START HARNESS WIRE
BROWN/BLACK BROWN/BLACK
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
PUSH-WIRE CONNECTION (Smart-Key equipped vehicles only)
NOTE: If performing the installation on a Retractable Key equipped
vehicle, cut off the remote start harness BROWN/BLACK wire and
insulate with electrical tape. (This wire is not used on this vehicle
but does carry +12 volts through it during remote start operation).
1. Locate the 12-pin WHITE key-in-sense connector under the igni-
tion switch. (FIGURE CC)
2. Using a razor knife carefully cut back 1”-2” of the electrical tape
to expose the wiring. ( CAUTION: BE EXTREMELY CARE-
FUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE CC
& DD for proper connector and pin location.
!
8
VEHICLE’S KEY-IN-SENSE WIRE REMOTE START HARNESS WIRE
YELLOW/BLUE YELLOW/BLUE
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
12-pin/2-pin
12-pin
Y/L
C I
G
A
E
B D F H J L
K