Maxi-Cosi Pria 70, Инструкция по эксплуатации

Страница: 23 / 36

D. General Vehicle Installation
44
43
Pull Vehicle Belt Across
Child Restraint
Without the TinyFit infant
insert
(A) , thread vehicle belt
UNDER seat pad in front of
buckle strap and out opposite
side. Buckle vehicle belt.
With the TinyFit infant insert
(B) , make sure harness
system is loose and headrest
is up. Thread vehicle belt
UNDER seat pad and TinyFit
infant insert on top of buckle
strap and out the opposite
side.
Do not place vehicle belt
over child’s legs.
3.
Tighten Vehicle Belt
Push down firmly on the
child restraint and while
pulling on the vehicle
shoulder belt to tighten.
4.
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE: If the latch plate
ends up just at the belt
path opening, grasp
the vehicle belts on the
opposite side of the child
restraint, as close to the
latch plate as possible.
5.
A locking clip will not fix all types of vehicle seat belt
problems.
Review section D-4 and your vehicle’s owner
manual for vehicle seat belt use with child restraints. The
locking clip is located on the back of the child restraint.
The following directions describe installing the child restraint
rear-facing. Same steps apply for forward-facing, except install
the restraint forward-facing and thread the vehicle belt in the
forward-facing belt path.
D-5
Using the Locking Clip
Place Child Restraint in
Vehicle Rear-Facing
With child restraint in the
reclined position, make
sure level line on the side of
the child restraint are level
with ground. Adjust child
restraint if needed.
NOTE: Hook top anchorage
hook (tether) on the base
and tighten. See section E-1.
1.
Thread Vehicle Belt
Thread the vehicle lap/
shoulder belt combination
through the rear-facing belt
slot.
2.
Do not use both the LATCH belt and vehicle
belt at the same time.
A
B