8
Safety Instructions
2.0 Safety Instructions
All electrical, assembly and dismantling work on the system must be carried out by qualified technicians
specifically trained to perform this work.
Only appropriately trained personnel may operate, clean, and disinfect the device.
BEWARE:
The system has not been certified to DIN EN 60601-1 when live. The system must
therefore be certified again by an appropriately trained technician after installation
with monitors, wiring etc.
MAVIG is not responsible for unauthorised or inappropriate handling of or changes to the system.
Changes to the system require written authorisation by MAVIG as inappropriate changes may have
adversely affect on the smooth operation, safety, and reliability of the system.
Any changes made to the system render the CE certification awarded to MAVIG invalid.
Thereafter, new approval must be obtained by the operator in accordance with the relevant statutory
provisions.
Avoid collisions between the system and other devices, walls, ceilings, etc. as these might seriously
damage it.
Any disregard of these instructions exempts the manufacturer from all liability and/or warranty obligations.
WARNING – Electric shock.
When installing and adjusting the Portegra2 and/or associated components, ensure
to cut off the power supply to the entire system.
Danger of Death!
CAUTION – Risk of injury or breakage.
The spring arm is always under tension. Before carrying out assembly or dismantling
work on the spring arm, always move it slowly to its upper limit.
There is otherwise a risk that the arm will suddenly shoot upwards when components
are removed. This could result in personal injury and/or damage to the system!
!
CAUTION – Risk of injury.
The manufacturer must be immediately informed of any damage caused to the system.
The system must not be used until the damage has been rectified. Disconnect the
system from the mains. Do not stand or work beneath the system.
!
CAUTION – Risk of injury.
Do not remove any covers, open any cable ducts, etc.!
!
Содержание Portegra2
