Matrox Mura D-Series, Руководство по сборке системы

Страница: 76 / 88

76 Matrox Display Wall – System Builder’s Guide
Validated chassis
The following chassis have been validated by Matrox to work with Matrox Mura IPX Series, Matrox D1480, and Matrox D1450 products.
Currently supported chassis
Advantech ACP-4010
Advantech ACP-4000
Note: For improved performance, we recommend you avoid using PCIe ®
×
4 slots or lower.
Cards supported
(maximum)
7
Part number ACP-4010MB-00BE/ACP-4010MB-00C (includes chassis and standard 82 CFM chassis fans)
Power supply 750 W redundant power supply (Advantech P/N: RPS8-750ATX-XE)
Power supply bracket Standard
Fan Two 120 mm x 120 mm x 25 mm 150 CFM fans (must upgrade from 82 CFM standard fans to 150 CFM fans)
Supported motherboards

Advantech ASMB-815

ASUS PRO WS X299 SAGE II

ASUS WS C621E SAGE
Notes  Power supply is not included with the chassis. It must be purchased separately.

The standard 82 CFM chassis fans must be replaced with two 120 mm x 120 mm x 25 mm 150 CFM fans
that must be purchased separately.

The chassis fans are connected directly to the motherboard and must run at full speed. To change the fan
speed, go to the system BIOS main page (EZ mode)

select
QFan Control

select the header to which the
fans are connected

change from
Standard
to
Full Speed
and apply the changes.
 Two dust protection sponge filters present on the front door and in front of the fans must be removed for
proper system ventilation.

If you use a wired mesh filter, the ambient temperature is limited to 40 degree centigrade. Filter requires a
18 x 18 size 304 stainless steel wire mesh.
Cards supported
(maximum)
5
Part number ACP-4000MB-00XE / ACP-4000MB-00F (includes chassis and standard 82 CFM chassis fans)
Power supply Advantech FSP700-80PSA (P/N:96PS-A700WPS2)
Power supply bracket Standard
Fan Two 120 mm x 120 mm x 25 mm 150 CFM standard cooling fans (must upgrade from 82 CFM standard fans
to 150 CFM fans)
Supported motherboards Advantech ASMB-815
Notes

Power supply is not included with the chassis. It must be purchased separately.

The standard chassis fans must be replaced with two 120mm x 120mm x 25mm 150 CFM fans that must
be purchased separately.

The dust protection sponge filter in front of the chassis must be removed for proper system ventilation
when the smart fan is enabled.

If you use a wired mesh filter in front of the chassis, the smart fan must be disabled. The chassis fans must
run at full speed.

Filter requires a 18 x 18 size 304 stainless steel wire mesh.

In the system BIOS, go to
Advanced

IT8528 HW Monitor Tab

Fan Configuration Tab

select the header to
which the chassis fans are connected

select
Smart Fan Mode:

Enabled
(when dust protection filter is removed)

Disabled
(when wired mesh filter is present)