Matrox Mura D-Series, Руководство по сборке системы

Страница: 28 / 88

28 Matrox Display Wall – System Builder’s Guide
ECA EVS-XL
Configurations
D-Series based controllers Third-party based controllers
Validated Yes No foreseeable compatibility issues
Maximum number of cards
supported
14
Maximum supported
Mura IPX Series
13
Maximum supported
D-Series
4
Motherboard Advantech PCE-7131 (SHB)
Advantech PCE-5B12-00A1 (Backplane)
Chipset Intel C246
Processor Intel® Xeon®E-2278GE CPU@ 3.30 GHz, or
Intel® Core™
i7-9700E CPU @ 2.60 GHz
Heatsink (for CPU) 2U CPU cooler
System BIOS version 5.13, 2020-04-09
System memory 32 GB DDR4 ECC Memory (Intel Xeon E-2278GE)
32 GB DDR4 non-ECC memory (Intel i7-9700E)
Chassis 5U (P/N: GHI-528)
Power supply 1550 W redundant power supply (P/N: Zippy MTW4-5F50V3H)
PCIe expansion slots

17 PCIe x16 3.0 slots (x16 mechanical, x16 electrical)

1 PCIe x16 3.0 slot (x16 mechanical, x4 electrical)
Notes

The dust protection sponge filter in the front door must be removed for proper system ventilation.
 If you use a wired mesh filter in the front door, the ambient temperature must not exceed 40 degrees C.
Filter requires a 18 x18 size 304 stainless steel wire mesh.
 Once the add-in cards are installed in the system, the baffle must be placed on the top for proper air
circulation. The baffle must be used only with small clips to properly secure the add-in cards with the board
retainer bar.

Requires 4 x 92 mm x 92 mm x 2 5mm 102 CFM chassis fans running at full speed.
 The smart fan must be disabled to run the chassis fans at full speed. In the system BIOS, go to
Advanced

HW Monitor Tab

SYSFAN1 smartfan
setting

and select
DISABLE
.
 Ensure to have the following settings for GPU. Go to the system BIOS main page

Chipset

System Agent
(SA) Configuration

Graphics Configuration

and select:

Primary Display

AUTO

Internal Graphics

AUTO
(select
Enabled
for Console)
 In the system BIOS main page, go to
Chipset

System Agent (SA) Configuration

Above 4GB MMIO BIOS
Assignment

and select
Enabled
.
 The P1PCIE1 x4 slot is unusable due to adjacent SHB slot.

The P2PCIE1 x16 and P2PCIE2x16 slots are unusable due to mechanical conflict with the SHB CPU fan.
 The P5PCIE5 x16 slot is unusable due to presence of red push button in the bracket slot area.

Card placement shown in the configuration table must be followed for better system ventilation.
 Any unused slots must be installed with solid brackets for proper system ventilation.

On-board console support with D-Series controller. Requires 3.05 or later drivers.
Slot
D-Series based controller Third-party based controller
Main Option Main Option
P1PCIE_1 N/A N/A N/A N/A
P2PCIE_1 N/A N/A N/A N/A
P2PCIE_2 N/A N/A N/A N/A
P3PCIE_1 MURAIPXI-E4JF A Third-party graphics hardware A
P3PCIE_2 MURAIPXI-E4JF A MURAIPXI-E4JF A