Motor does not start.
•
Check time delay fuse or circuit breaker.
•
Replace brushes. See MAINTENANCE
section.
•
Fuse problem.
•
Brush worn.
Brush sparks excessively
when switch is released.
•
Replace brushes. See MAINTENANCE
section.
•
Brush worn/damaged.
Blade hits table.
•
See ADJUSTMENT section.
•
Misalignment.
Angle of cut is inaccurate.
•
Use miter lock lever. See ADJUSMENT
section.
•
Vacuum or blow out dust. WEAR EYE
PROTECTION!
•
Miter table is unlocked.
•
Too much sawdust under table.
Cutting head cannot fully
raise or blade guard cannot
fully close.
•
Contact authorized service center.
•
Contact authorized service center.
•
Clean and lubricate moving parts.
•
Parts failure.
•
Pivot spring not replaced properly after
service.
•
Sawdust buildup.
Cutting head cannot fully
raise or blade guard cannot
fully close.
•
Use miter lock lever. See ADJUSMENT
section.
•
Vacuum or blow out dust. WEAR EYE
PROTECTION!
•
Miter table is unlocked.
•
Too much sawdust under table.
Blade binds, jams, or burns
wood.
•
See OPERATION section.
•
Replace or sharpen blade.
•
Replace blade.
•
Replace blade.
•
Improper operation.
•
Dull blade.
•
Improper blade.
•
Warped blade.
Saw vibrates or shakes.
•
Replace blade.
•
Tighten arbor bolt.
•
Saw blade is damaged.
•
Saw blade is loosened.
Laser line projection is hard
to see.
•
Move the miter saw to the work area with
proper light.
•
Clean laser lens with a soft, dry brush.
•
Light in work area is too bright.
•
Sawdust on the laser lens.
PROBLEM
PROBLEM CAUSE
CORRECTIVE ACTION
Page 40
TROUBLESHOOTING
Содержание 240-0028
Страница 44: ......
