Master Forge 240-0028, Руководство оператора

Страница: 18 / 44

ASSEMBLY
Page 17
UNLOCKING THE SLIDE BAR (FIG. 8)
Loosen the slide lock knob (A) counter-clockwise, then
push the slide bar (B) forward or backward. The slide bar
should always be locked in position with tightening it
clockwise when transporting or storing.
The slide lock knob (A) is located on the top of the bevel
arm (C).
FIG. 8
WARNING:
In some operations, the work piece
clamp assembly may interfere with the operation of the blade
guard assembly. Always make sure there is no interference
with the blade guard prior to beginning any cutting operation
to reduce the risk of serious personal injury.
CAUTION:
There are two mounting holes for the
work piece clamp. These are located just behind the miter
fence on the left and right side of the base.
FIG. 7a
FIG. 7b
INSTALL THE WORK PIECE CLAMP (FIG. 7a-7b)
The work piece clamp provides greater control by clamping
the work piece to the miter table. It also helps to prevent the
work piece from creeping toward the saw blade. This is very
helpful when cutting compound miters. Depending on the
cutting operation and the size of the workpiece, it may be
necessary to use a C-clamp (not included) instead of the
work piece clamp to secure the work piece prior to making
the cut. The work piece clamp can be installed and used
on either side of the blade.
CAUTION:
The work piece clamp has a quick
release button (E) that makes positioning of the work piece
clamp effortless. Push the quick release button (E) on the
front of the work piece clamp to quickly release the work
piece.
To install the work clamp:
1. Place the work piece clamp shaft (A) in the hole (B).
2. Rotate the knobs (C, D) on the work piece clamp to move
it up or down as needed.
D
B
A
B
E
C
1 3
2
2
B
A