Master Forge 240-0028, Руководство оператора

Страница: 15 / 44

Page 14
WARNING:
To avoid injury, do not connect this miter saw to a power source until it is completely assembled and
adjusted and you have read and understood the operator’s manual.
CAUTION:
Many of the illustrations in this manual show only portions of the miter saw. This is intentional so that
we can clearly show points being made in the illustrations. Never operate the saw without all guards securely in place and
in good operating condition.
FIG. 2a
FIG. 2b
(ITEMS NOT SUPPLIED)
Flat head screwdriver
3mm Hex key
5mm Hex key
10mm wrench /Adjustment wrench
Framing square
Combination square
(ITEMS SUPPLIED)
Blade wrench (1 pc)
YOU WILL NEED
ASSEMBLY
CAUTION:
To avoid injury and damage to the saw,
transport and store the miter saw with the cutting head
locked in the down position. Never use the head lock knob
to hold the cutting head in a down position for cutting
operations.
NOTICE:
To avoid damage, never carry the miter saw by
the blade guard, power cord, miter lock lever or cutting head.
ALWAYS use the designated carrying handles (B, C) located
on the top of the cutting head and on the end of the slide
bar. (Fig. 2b)
UNLOCKING AND LOCKING THE CUTTING HEAD (FIG. 2a-2b)
Unlocking the cutting head:
• To raise the cutting head from its storage transport position.
Firmly grasp the “D” handle and apply downward pressure
while at the same time pulling the head lock knob (A).
• Slowly raise the cutter head to the up position.
Locking the cutting head:
When transporting or storing the miter saw, the cutting head
should always be locked in the down position.
• Firmly grasp the “D” handle and push the cutting head
down to its lowest position.
• Push the head lock knob (A) into the locking hole and
check that the head lock knob is locked in place by turning
the knob clockwise.
B
A
Lock
Unlock
C