Masimo Rad-87, Руководство оператора

Страница: 93 / 101

Rad-87 Pulse CO-Oximeter Operator’s Manual 9-1 9-1
9
s e r v i c e / m a i n t e n a n c e
I n t r o d u c t i o n
This chapter covers how to test the operation, properly clean and how to obtain service for
the Rad-87 Pulse CO-Oximeter.
Under normal operation, no internal adjustment or recalibration is required. Safety tests and
internal adjustments should be done by qualified personnel only. Safety checks should be
performed at regular intervals or in accordance with local and governmental regulations.
WARNING: ELECTRICAL SHOCK AND FLAMMABILITY HAZARD - BEFORE
CLEANING THE RAD-
87
, ALWAYS TURN IT OFF AND DISCON-
NECT THE POWER CORD FROM THE AC POWER SUPPLY.
The Rad-87 Pulse CO-Oximeter is a reusable device. The device is supplied and used
non-sterile.
C l e a n i n g
The outer surface of the Rad-87 Pulse CO-Oximeter can be cleaned with a soft cloth
dampened with a mild detergent and warm water solution. Do not allow liquids to enter
the interior of the instrument. The outer surface of the instrument can also be wiped down
using the following solvents: Cidex Plus (3.4% Glutaraldehyde), 10% Bleach, and 70%
Isopropyl Alcohol.
CAUTIONS:
■
DO NOT AUTOCLAVE, PRESSURE STERILIZE, OR GAS STERILIZE THE
RAD-87.
■
DO NOT SOAK OR IMMERSE THE MONITOR IN ANY LIQUID.
■
USE THE CLEANING SOLUTION SPARINGLY. EXCESSIVE SOLUTION CAN FLOW
INTO THE MONITOR AND CAUSE DAMAGE TO INTERNAL COMPONENTS.
■
DO NOT TOUCH, PRESS, OR RUB THE DISPLAY PANELS WITH ABRASIVE
CLEANING COMPOUNDS, INSTRUMENTS, BRUSHES, ROUGH-SURFACE
MATERIALS, OR BRING THEM INTO CONTACT WITH ANYTHING THAT COULD
SCRATCH THE PANEL.
■
DO NOT USE PETROLEUM-BASED OR ACETONE SOLUTIONS, OR OTHER
HARSH SOLVENTS, TO CLEAN THE OXIMETER. THESE SUBSTANCES
AFFECT THE DEVICE’S MATERIALS AND DEVICE FAILURE CAN RESULT.
Refer to Section 8, Cleaning and Reuse of Masimo Reusable Sensors and Cables for
cleaning instructions of the sensor.