SPARTAN IRONWORKER
ANGLE SHEARING STATION
© MARVEL MFG. CO., INC. MANUAL
PL/OMIW-2CYL-V2
(08//07)
F-8
Two socket head cap screws hold each of the
stationary blades in place. Screws "B" hold the
lower blade (D) in place, and screws "C" hold the
side blade (E) in place.
5.
Re-install the blades with a an unused
edge in the cutting position. If all of the
blade's cutting edges are worn, install a
new blade.
6.
Continue with step 3 of "Adjusting the
Stationary Blades", below.
Adjusting the Stationary Blades
The stationary blades are adjustable so the correct
clearance between the stationary blades and the
fixed blade can be achieved.
Avoid serious injury. Turn off
the machine's power and lock
it out before adjusting or
servicing the machine.
1.
Turn
off
the
main
electrical disconnect switch and lock it in
the "Off" position.
Avoid injury. The guard weighs
22 lbs. Use care when removing
it from the machine.
2.
Remove the three socket head cap screws
(A, previous column) that hold the guard
in place and carefully remove the guard.
3.
Position the following switches as
indicated:
o
Auto / Manual switch to "Manual".
o
Shear / Notch switch to "Shear".
o
Normal / Jog switch to "Jog".
4.
Close the notching station's guard.
5.
Turn the Main Electrical Disconnect
switch on.
6.
Reset the Emergency Stop pushbutton(s).
7.
Press the "Pump On' pushbutton.
Note: If the hydraulic pump does not come on
make sure the Emergency Stop pushbutton(s) are
reset.
Avoid serious injury. When
the foot switch is pressed, the
moveable blade will descend.
Keep away from the blades.
Avoid damaging the machine.
Make sure the moveable blade
will not strike the stationary
blades.
Important: If the moveable blade will strike
the stationary blades continue with step 9,
below.
8.
Press the foot switch until the moveable
blade descends behind the stationary
blades and then release the foot switch.
WARNING
CAUTION
WARNING
CAUTION
D
E
C
B
