SPARTAN IRONWORKER
PUNCHING STATION
© MARVEL MFG. CO., INC. MANUAL
PL/OMiW-2CYL_V2
(08/07)
D-7
combination you are using determines which die
well must be under the ram.
Reversible die holders have two die wells - one
large (E) and one small (F).
To Reverse the Die Holder:
Avoid serious injury.
Turn off the machine's power
and
lock
it
out
before
adjusting the machine.
1.
Turn
off
the
main
electrical disconnect switch and lock it in
the "Off" position.
2.
Open the stripper.
3.
Remove the front section of the work
table by removing the four socket head
cap screws which secure it in place.
4.
Loosen the six socket head cap screws (C)
which mount the die holder to the
machine.
Six socket head cap screws (C) hold the die
holder in place.
Avoid serious injury. The die
holder is heavy. Use proper
lifting technique and a firm
grip to avoid injury.
5.
Slide the die holder off the end of its
mounting surface, turn it around, and slide
it back onto the mounting surface.
6.
Continue with step 2 of "Installing and
Centering a Punch and Die", page D-7.
INSTALLING AND CENTERING A
PUNCH AND DIE
Important:
Refer
to
"Punch
and
Die
Selection" on page D-9 for important
information on the proper selection of punches
and dies before proceeding with these steps.
Important: Misalignment of the punch and die
is the primary cause of failure for these
components.
Avoid serious injury.
Turn off the machine's power
and lock it out before servicing
the machine.
1.
Turn off the main electrical disconnect
switch and lock it in the "Off" position.
2.
Install a die (A) with the die's working
hole facing up, and the larger, discharge
hole facing down. The top of the die must
be flush with, or slightly higher than, the
top of the die holder.
WARNING
CAUTION
WARNING
E
F
C
C