© Martin Engineering GmbH
18
M3289UK-01/17
Installation
5.
Push the angled gearbox motor with mounting plate for motor
torque support (1, Fig. 4) onto the shaft.
6.
Fix bolts (4, Fig. 4) of the pillow block on both sides with the
nuts.
Fig. 4:
NOTE
Make sure that the feather key (2, Fig. 5) lies in the keyway
(1, Fig. 5) of the axle.
NOTE
The mounting plate must be installed from below onto the
tensioner. The angled gearbox motor should always be placed on
the shaft flush with the conveyor belt.
Fig. 5:
NOTE
The angled gearbox motor (1, Fig. 6) can only be mounted in the
transport direction (2, Fig. 6) on the left side, a changeover to the
right side is not possible.
1
2
1
2
